How to avoid distortion of stamping parts during processing

We are in the process of stamping parts processing, the main reasons of distorted because of residual effects, because when we were in the stamping, with the existence of the gap, so will cause in the side of the concave die stamping materials by stretching, and on the DCS side will be under compression, so we are in the process of stamping, Compaction material is to prevent the distortion of stamping process in the middle of the heavy, in addition, professional Hebei stamping parts processing manufacturers will give you some other ways to prevent distortion.

The first point is we use stamping processing of die must be reasonable design, in general, we in the stamping process, the order of the blanking may also affect the precision of the stamping forming, therefore, we are comparing stamping small parts, the materials to arrange the cutting with larger area, then arrange the area is lesser, In order to reduce the impact of impact load on stamping parts.

The second point is to compress the material. First of all, we must customer service is the traditional mold design, which can make the unloading plate movement balance in the stamping process, so that the material can be pressed, in the key parts of the formation of the part, the unloading plate must do insert type structure.

The third point is that we can make the punch end into an inclined plane or a lone line. This is also a limited way to reduce stamping processing to alleviate the impact load, alleviate the impact load, so as to achieve the same production of stamping parts turning and twisting effect.

The above is the professional hebei stamping parts processing manufacturers, for you to introduce, we in the process of processing how to avoid making stamping parts distortion is an important way, I hope that through our introduction, to help your processing.